Instructions / Assembly

2) Selecting the Location
WARNING: All fire pits, match lit kits, spark ignition, safety pilot and electronic ignition systems are designed and intended for
outdoor use only.
WARNING: All fire pits must have a gas shutoff on the outside of the exterior of the fire pit to allow for emergency shut off and
maintenance.
WARNING: Select a location where the fire pit can be attended during operation. Never leave an operating fire pit unattended or
by someone not familiar with its operation or emergency shut off locations.
WARNING: Both children and adults should be alerted to the hazards of high surface temperatures and should stay away to avoid
burns and clothing ignition.
WARNING: Young children should be carefully supervised when they are in the area of fire pit.
WARNING: Clothing or other flammable materials should not be placed on or near fire pit.
WARNING: Fire pits create very high temperatures - Combustibles must be located far enough away that there is no risk of
ignition.
IMPORTANT: Unless previously tested, it is recommended that material such as granite, marble or other dense stone be kept
away from heat and especially flame due to risk of cracking. Manufacturer is not responsible for damage.
Fire Pit Clearances –
Sides Surrounding Fire Pit 48” From Structure or Combustibles
Overhead Clearance Nothing Over Head
 Select a location with good drainage.
 Choose a location that allows easy access for installation and maintenance of the fire pit.
 Pick a location that allows sufficient horizontal room to enjoy the fire pit while allowing a safe distance from the heat
and flame.
3) Construction of the Enclosure
WARNING: All fire pits must have a gas shutoff on the outside of the exterior of the fire pit to allow for emergency shut off and
maintenance.
WARNING: Always use proper materials and construction for gas supply.
WARNING: The interior void space of the enclosure cannot be filled with any material (gravel, crushed rock, concrete, etc.)- It is a
requirement to have a minimum of 2” under the valve box for proper ventilation drainage.
WARRANTY REQUIREMENT: The enclosure must be constructed on a stable surface. The weight of the fire pit burner must be
supported by the pan and not by any control/valve box. For electronic ignition models the control/valve box must be above grade
with adequate drainage to prevent water damage to the controls inside the box. We cannot guarantee the steel tray will be perfectly
flat and will not warp due to heat
IMPORTANT: Follow the enclosed instructions for the installation of the fire pit enclosure.
Installation
We suggest that our products be installed by professionals
that are locally licensed by the authority having
jurisdiction in gas piping.