Installation Guide

ManualsBrandsFossil Blu ManualsFarmhouse Kitchen SinksLuxury Dark Patina 12-Gauge Copper 30 in. Single Bowl Farmhouse Apron Kitchen Sink with Accs and Flat Front

General Recommendations:

Please read installation and care instructions thoroughly. Inspect your sink

for any noticeable damage before installation. Check all local applicable

umbing and building codes.

These instructions are based on application to composite material or solid

surface countertop installation only; countertop application to stone, marble,

granite or butcher-block should be referred to an experienced countertop

fabricator for custom installation.

Because Fossil Blu Farmhouse sinks are individually handmade, we suggest

using experienced and professional installers only. For custom cutting of

countertop and installation of the actual sink, on-site installation is also

recommended. Acceptable variances are approximately 1/8 of an inch.

Alignment to the cut-out and precise application and trimming of any

adhesive sealant are critical to a superior fit and finished look. Please take

extra care in this regard.

Fossil Blu Farmhouse sinks require custom order cabinets. Please consult

your cabinet dealer.

Fossil Blu sinks does not accept any liability for damage to countertop, sink

fixture, faucets or personal injury during installation. Warranty is void if

installation instructions are not followed.

Installation Options:

Fossil Blu Farmhouse sinks offer installation options depending on your design.

Undermount Installation Flush-Mount Installation Built-Up Installation

• Tape Measure

• Hacksaw / Jigsaw

• Rags

• Pencil (Not Ink)

• Framing Square

• Ear a

nd Eye Protection

• Shims

• Denatured Alcohol

• Silicone Adhesive

Sealant

• Wood Braces

Be sure to use proper tools and

always wear personal safety devices

for your protection.

stallation and

Care Manual

Fireclay Farmhouse Kitchen Sinks

CAUTION: Undermount sinks require that your countertop is fabricated to exacting standards and the sink be installed

using meticulous procedures. For these reasons, we suggest you leave the installation to a seasoned professional.

Models Covered:

FSW

1000, FSW1001,

FSW

1002, FSW1003

(For copper models, see page 4)

Tools / Materials Needed: