Installation Instructions

7. JOINTS
If a joint in the turf is required, butt both of the surfaces together ensuring the pile is running in the same
direction. You will need adhesive and join tape. Check that the pile is in the same direction on both sides.
Fold back 1ft on each side along the length of the joint and trim 1in from each edge, cutting between
tufts. Apply adhesive along each edge of the backing in 2 lines. Fold one side of the turf onto the join tape. Then
slowly fold over the other side of the joint. A gap of 1/10in between the sections generally gives the best results.
Once joined, laying weighted planks along the joint is a good idea to ensure an invisible joint during drying.
In addition, we recommend to fix the turf with screws into wooden poles every 4 ft always connect both sides in
the same pole). This is absolutely necessary of the length of the join is more than 24ft.