Owner's Manual

How to clean the transducer:
1) Clean with clean water or citric acid if there is scale in it.
2) Brush off the scale from the surface.
3) Rinse the transducer with clean water.
How to clean the basin humidifier:
1) Clean the water basin with soft cloth or use citric acid if there is scale in it.
2) If the scale is covered on the security switch, drop citric acid for 2-5 mins on the scale and clean it out with the brush.
3) Rinse the water basin with clean water.
How to clean ceramic filter:
1) Clean and activate the ceramic ball filter after using 1000L water regularly. Depend on water quality, if ceramic balls are
dirty, the filter needs to be cleaned more frequently.
2) It can be dipped in vinegar about 5 minutes. Then rinse it cleanly with clean water.
3) Put the filter under the sun for 4~6 hours.
4) You can purchase replacement filters.
* Trouble Shooting Guide
If any trouble is found in normal operation, please kindly refer to below:
Trouble
Possible cause
Possible solution
Power lamp is off when switched on
Humidifier is not plugged in.
Plug the humidifier into a powered
electrical socket.
Power cord is damaged.
Immediately discontinue use and
contact Customer Support.
Humidifier is defective or
malfunctioning.
Power lamp is on when switched on,
but no mist come out
Humidifier is not turned on.
Press the power button to turn it on.
The target humidity is reached.
Increase the target humidity or change
mode.
Water shortage indicator is on
No water in the tank.
Refill the water tank wait at least 1
minute.
Water level is low.
The water level required has not yet
reached the vaporization compartment.
Wait at least 1 minute.
The water tank isn‟t well positioned.
Check the positioning of tank on the
base.
The humidifier isn‟t on a flat surface.
Check the positioning of the
humidifier.
Humidifier produces an unusual smell
Humidifier is new.
Take out water tank, open cover, let it
stay 12 hours in cool position.