Owner's Manual

function is still working under this state.)
- When the expected humidity is higher than the current humidity, the humidify function will work again.
Touch the button till the LED display shows “Co”, or long touch the button, it means to cancel the humidity setting
and back to AUTO MODE.
8. Touch the “TIMER” button to set your desired working time from 01-12 hours. Touch till display shows
“Co” or long touch the button, it means to cancel the timer setting.
9. First touch the “UV” button to start “HEATING” function, display will show HEATING symbol as
well. Second touch the button to start “UV” function, display will show UV symbol . Third touch to cancel
“HEATING” function. Forth touch to cancel “UV” function.
10. First touch the “INDICATOR LIGHT” button , indicator light will be green. Second touch light will be blue.
Third touch light will be warm yellow. Forth touch light will be 7-color changing. Long touch the button to turn
on/off the light.
11. Auto Shut-Off: Once the water in the basin is too little to keep the humidifier working, the humidifier will
automatically stop working and have 3 beep sounds (No sound under NIGHT MODE). Display will only show
waterless symbol and “ON/OFF” buton will be red. Refill water tank, and touch “ON/OFF” button
again to restart.
During working, remove water tank, humidifier will stop working and “OF/OFF” button will be red. Put
back water tank, humidifier will work again.
The following is not considered faulty operation:
1. If your water is very hard (containing abnormally high levels of minerals) the humidifier may produce white dust. This
is not a malfunction. The solution would be to clean the filter more often or use softer water.
2. If you stand very close to the humidifier, you will hear the gurgling sound of water. This is normal.
3. The humidifier operates very quietly but it is not completely silent. Noise levels less than 35dB(A) is considered
normal.
* Maintenance
In a case when the water is hard which means water contains too much calcium and magnesium, it can cause a “white
powder” problem and leave heavy scales on the surface of water basin, transducer and inner surface of the water tank.
Scales on the surface of transducer will let the humidifier work improperly.
We recommend:
1) Use cold boiled water or distilled water.
2) Clean the transducer, water tank and basin humidifier every week.
3) Change the water in water tank more often to keep it fresh.
4) Make sure to pour out water from the water tank and dry the water basin before you store it unused for a long time.
5) Clean the whole humidifier and make sure that all parts of the humidifier are dried completely if it is supposed to be
leaved unused for a long time.