Owner's Manual

* Instructions for usage
1. Put the humidifier on a flat surface.
2. Remove the top cover, fill water into the water tank and then put back the top cover. Alternatively, take out water
tank for filling water, afterwards put the water tank back on the main base.
3. Check if the rated voltage meets the input voltage, and plug into the socket.
4. The LED display will flash once and a beep sound will be heard. The humidifier is in standby state. “ON/OFF”
button will be red.
5. Touch the “ON/OFF” button on the control panel to switch on the humidifier, display will light up and all
buttons will be white. Indicator light will be on (with 7-color changing). Display shows current humidity, current
temperature and “AUTO” symbol . It means humidifier works under AUTO MODE.
Humidifier will decide running humidity based on current temperature as below table. Heating, UV and timer
function is optional.
Temperature of the
air, degrees Celsius
≤19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
≥37
Humidity (%)
65
60
58
57
55
53
50
48
45
43
40
38
36
35
34
32
31
30
25
6. Touch the “MIST OUTPUT” button to adjust the mist output, meanwhile “AUTO” symbol will disappear.
= level 1, = level 2, = level 3.
Long touch “MIST OUTPUT” button to entre NIGHT MODE. Display will become dim and show NIGHT
MODE symbol , indicator light will be off. 10 seconds later, whole display will be off except NIGHT MODE
symbol . There is no operative sound and waterless warning sound under this mode. Long touch the button
again to exit NIGHT MODE.
7. Touch the “HUMIDITY” button to set your expected humidity from 30%RH to 75%RH, display will show
symbol . Touch once, it will increase by 5%RH.
The LED display will flash the expected humidity three times and then turn back to show the current humidity. The
humidifier enters into the constant humidity function, the expected humidity is set.
Under constant humidity function, humidifier will adjust mist output level automatically.
- When the expected humidity is 1%RH ~ 10%RH higher than current humidity, humidifier works in level 1.
- When the expected humidity is 10%RH ~ 15%RH higher than current humidity, humidifier works in level 2.
- When the expected humidity is 15%RH higher than current humidity, humidifier works in mist output level 3.
- When the expected humidity is less than the current humidity, the devise will be in sleeping state. (Timer