OWNER’S MANUAL HUMIDIFIER MODEL: SPS-111W Thank you for purchasing your new Humidifier. The humidifier helps you to restore an appropriate level of humidity and eliminate the discomfort associated with dry air. The ventilation system diffuses water in the form of a cool or warm vapor in order to provide the desired level of humidity. This vapor is characterized by a mist discharged through the diffusion nozzle. We wish you many years of healthy indoor air with this efficient and effective product.
SAFETY WARNING * Read all the safety instructions carefully before use and keep this instruction manual for future reference: 1) Please follow all the safety precautions listed below for safety and to reduce the risk of injury or electrical shock.
* Correct Humidity Level: What exactly is relative humidity: Relative humidity is the amount of water vapor in the air, expressed as a percentage of the maximum amount that the air could hold at the given temperature. We normally mark it with %RH, like 45%RH. Atmospheric air always contains water vapor, the percentage of which depends on the meteorological conditions. The higher the temperature is the more the air keeps water vapor. Therefore, we use the concept of „relative humidity”.
*Product Overview * Display *Control panel
*Remote Control * Features: High efficient in humidification with large output. Low energy consumption, save 85-90 percent of electricity than normal stream humidifier. Long lifetime. Automatic control of humidity level, lack-of-water security protection. Base with aroma cotton, to wet it with aromatic oil. TECHNICAL DATA Model: SPS-111W Power supply: 100V 50/60Hz Humidify power: 110W Water tank capacity: 4.3L Evaporation Rate: 300ml/H (±50ml/H) Cool mist Noise level: ≤35dB(A) Product size: 23.5x20.3x32.
* Instructions for usage 1. Put the humidifier on a flat surface. 2. Remove the top cover, fill water into the water tank and then put back the top cover. Alternatively, take out water tank for filling water, afterwards put the water tank back on the main base. 3. Check if the rated voltage meets the input voltage, and plug into the socket. 4. The LED display will flash once and a beep sound will be heard. The humidifier is in standby state. “ON/OFF” button will be red. 5.
- function is still working under this state.) When the expected humidity is higher than the current humidity, the humidify function will work again. Touch the button till the LED display shows “Co”, or long touch the button, it means to cancel the humidity setting and back to AUTO MODE. 8. Touch the “TIMER” button to set your desired working time from 01-12 hours. Touch till display shows “Co” or long touch the button, it means to cancel the timer setting. 9.
How to clean the transducer: 1) Clean with clean water or citric acid if there is scale in it. 2) Brush off the scale from the surface. 3) Rinse the transducer with clean water. How to clean the basin humidifier: 1) Clean the water basin with soft cloth or use citric acid if there is scale in it. 2) If the scale is covered on the security switch, drop citric acid for 2-5 mins on the scale and clean it out with the brush. 3) Rinse the water basin with clean water.
Humidifier makes a loud or unusual sound Dirty water or water sitting too long. Clean water tank, fill with clear water. Residual smell from diffusing aroma oil on the aroma cotton. Remove the aroma cotton, rinse it under clean water and allow it to dry. Resonant in water tank when water is too low. Fill water into water tank. Humidifier is on an unstable surface. Move the humidifier to a stable flat surface. Water tank is positioned incorrectly.
Water being used has a high mineral content. Use distilled water with the humidifier. If distilled water is not available, use purified or filtered water. Remember to clean water tank at least once a week. Humidifier was not properly cleaned after last use. Clean humidifier. Mist is coming out from the base Water tank is not positioned correctly. Turn off and unplug the humidifier, then align the water tank cover with its respective opening in the inner chamber.
FCC Warning This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any inte rference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
