User's Manual

1 KT4557 BLUETOOTH SPEAKER
2 . AC ADAPTER 4 . USER MANUAL
. 3 . AUX IN CABLE
GETTING STARTED
EN-8
ACCESSORIED INCLUDED
Carefully remove the unit and all accessories from the gift box. Please verify that you
have all the following accessories before you recycle the gift box
CHARGING YOUR PORTABLE DEVICE WITH THE KT4557
This speaker features a USB port for charging your portable device (iPod, iPhone,
Android®, etc.) when used with the USB charging cord that came with your device.
1.Turn on the speaker by sliding the Power On/Off Switch to “ON”.
2.Plug one end of the USB cable (not included) into the USB Charging Port located
on the back of the KT4557. Plug the other end of the cord into the device you wish
to charge.
3.Observe the battery charge indicator on your device to make sure the charging
process starts normally.
4.Unplug the USB cable when your device is fully charged.
CAUTION:
Before charging, please refer to the user manual of the device you wish to charge to
make sure the charging current requested does not exceed 1A (1000mA). Overloading
the charging circuit may damage the KT4557 permanently and void the warranty.
Notes:
1.There will be no charging function when KT4557 is turned “OFF”.
2.Some smart phones and portable devices use proprietary USB connections and
circuitry and may not charge when plugged into the USB port. This includes older
iPod models including the iPod classic. Please refer to your device user manual
before you attempt to charge them.
PROTECT YOUR FURNITURE !
This model is equipped with non-skid rubber 'feet' to prevent the product from moving
when yo u oper a te the c o ntro ls. These 'feet' are made from n on-m i grat ing rub ber
material specially formulated to avoid leaving any marks or stains on your furniture.
However certain types of oil based furniture polishes, wood preservatives, or cleaning
sprays may cause the rubber 'feet' to soften, and leave marks or a rubber residue on the
furniture. To prevent any damage to your furnitur e we strongly recommend that you
purc h ase sm al l se lf -a dh es i v e fe lt pa ds, ava ilab le at har dware s tore s a nd hom e
improvement centers everywhere, and apply these pads to the bottom of the rubber
'feet' before you place the product on fine wooden furniture.
Notes:
1.We recommend connecting the Headphone jack of your external audio device to
the Aux Input Jack on the KT4557. Then use the volume control on the connected
device to adjust the loudness level.
2.If you connect the Line-Out Jack of your external audio device to the KT4557 Aux
Input, the audio level will be very high and you can't adjust the volume level.
3.When using the AUX Input function, the Bluetooth pair (link) will be temporarily
disconnected until the Input Button is pressed again to select the Bluetooth enabled
device.
4.Turn the KT4557 power off when you have finished listening. Don't forget to switch
off the power of your external audio device as well.