Operation Manual

www

.foscam.co

Shenzhen

Foscam

Intelligent

Technology

Co.,

Limited

Tel:

755

2674

5668

Fax:

755

2674

5168

2. Enable UPnP and DDNS in the camera’s settings page. We recommend you to use the DDNS by factory

default.

Figure 2.7

Figure 2.8

3. You can see the port of your camera here. If you want to set Remote Access for several cameras on the

same network, you will need to change the HTTPS port for each camera.

Figure 2.9

4. If the UPnP of the router has been enable, you do not need to perform following steps. Otherwise, you

need to select one of the following methods to configure port forwarding on your router. For these steps, we will

be using the TP-LINK brand wireless router as an example.

 If there is a UPnP function in your router：

Choose “Forwarding > UPnP”, make sure that the Current UPnP Status is Enabled.

Select Yes and click Save.

Click Enable DDNS and click Save.

The content in the Manufacture’s DDNS

column is the domain name of your camera.