User Manual

User’s Manual
11
5.3.2 Connect Fixture to a Wireless DMX Transmitter
After fixture is switched on, and if there is no new transmitter, fixture will connect to the old
transmitter automatically, no need to re-connect it.
To put table ligh t into w ireless DMX, receive mode, press MENU button repeatedly until you see
“Wireless DMX”, press ENTER to select [ Transmit] / [ Receive]. Press UP/DOWN to select
[ Receive], and press ENTER to save the setting.
To pair fixture and transmitter (make sure wireless DMX indicator is Off), press the pair button on the
transmitter, the fixture wireless DMX indicator will start to fast flashing fast and then stay on, pair succeeds.
5.3.3 Connect Fixture to Fixture(s) (Master/Slave mode)
Make sure you have already cleared the fixtures wireless DMX memory (Please refer to 5.4.1 Erase
Fixture Wireless DMX Memory). To set one fixture as Master unit, press MENU button until you see
“Wireless DMX”on the OLED display. Then press ENTER button and use UP/DOWN button to
select “Transmit”. Now press ENTER to save your setting. Now you can select the preset programs.
To se t other f ixt ure s a s S lave unit, press MEN U button until you see “Wireless DMX”on the OLED
display. Then press ENTER button and use UP/DOWN button to select “Receive”. Press ENTER to
save your setting. The fixture(s) now will run in sequence with the Master unit.
Note: Make sure that all your slave units are set to the same DMX channel mode with the
Master unit.