User Manual

User’s Manual
10
5.2 DMX Addressing
Each fixture must be given a DMX address so that the correct fixture responds to the correct control signals.
This DMX address is the channel number from which the fixture starts to “listen” to the digital control
information being sent out from the controller.
This fixture has 3 DMX channel modes, 4, 6 and 10 DMX channels. To s et u p fixture DMX address, first select
DMX channel mode. The highest DMX address for this fixture is 512. To set up fixtu re DMX st arting address ,
follow the steps below:
- Switch on the fixture, press MENU till“Channel” appears;
- Press “UP” or “DOWN” button to select 4CH or 6CH or 10CH;
- Press “ENTER” to confirm your select.
- Press “MENU” repeatedly to come back to “Address 001”;
- Set up DMX address by scrolling “UP”/” DOWN” button.
- Press “ENTER” to save your setting.
5.3 Wireless DMX Setup
To op erate the tab le light in DMX mode, users mu st con nect it to a W-DMX compatible wireless DMX
transmitter first.
There is one wireless DMX indicator on the control panel. This indicator shows status of wireless DMX
connection.
Indicator Status
Description
Blue light on
Fixture receiving wireless DMX signal from transmitter.
Blue light slow flashing
Fixture already connected to transmitter, but no signal coming from
transmitter.
Blue light fast flashing
Fixture no connection to transmitter; fixture keeps. Wireless DMX memory
from last pair.
Blue light off
Fixture no connection to transmitter, and no any wireless DMX memory.
5.3.1 Erase Fixture Wireless DMX Memory
To connect table light to a NEW wireless DMX transmitter, users need to clear old wireless DMX
memory first. Continue pressing “MENU” button till you see “Wireless DMX”, now press “UP/DOWN”
to select “Clear” and press “ENTER” to erase old wireless DMX memory. Then the blue light will turn
off in about 5 seconds.
If you clear the wireless DMX memory of a Master unit, you will also clear the memory of all Slave
units; If you clear the wireless DMX memory of one Slave unit, you will clear the memory of this
unit only.