Troubleshooting guide

Three parameters need to be configured in order to set up the UPS. Refer to following diagram.
Parameter 1: it is used for the
different configuration options. There
are 15 programs to set up. Refer to
the table below.
Parameter 2 and parameter 3: they
represent the setting options or values
of each program.
3-6. Abbreviations on the LCD display
3-7. UPS parameter settings
ENA
DIS
ATO
BAT
NCF
CF
SUB
ADD
ON
OFF
FBD
OPN
RES
PAR
Enable
Disable
Auto
Battery
Normal mode (not CVCF mode)
CVCF mode
Subtract
Add
On
Off
Not allowed
Allow
Reserved
Parallel
Abbreviation Display content Meaning
Parameter 1
Parameter 2 Parameter 3