Product Manual

CO7338.1 27 IN20525 Rev D 3/30/2009
columns.
g. Adjust locking latch bar adjusting nut so that the bottom of the topmost latch bar slot is at
least 2” below locking latch. After adjustment, tighten jam nut underneath column top
plate, Fig. 11.
h. If entire 2” clearance cannot be attained by adjusting the locking latch bar, adjust the
cable. Turn cable adjusting nut to raise the locking latch 2” above bottom of latch bar
slot. Tighten cable jam nut.
i. Lower lift and remove vehicle.
j. Raise the lift to full height. LISTEN and WATCH as the first locking latch clicks into
place. Synchronize the other three columns with this column by adjusting their cables
so all four latches click at same time. Tighten jam nuts.
When making changes to adjustment nuts on cable end or latch bar stud, always leave at least
two threads showing between nut and stud end.
Latches may not click in at the same time when vehicle is being raised. They should be close.
Be sure all four corners have passed the locking latch bar slot before lowering lift on locking
latches