Product Manual

CO7338.1 26 IN20525 Rev D 3/30/2009
leaks. Repair or replace as required.
1 Check and tighten the hydraulic cylinder rod nuts holding the cable pull bar.
4. TRACKS for Rolling Jack and Oil Drain Pan
Inspect rolling jack/oil drain pan tracks for cleanliness, corrosion, excessive wear or damage.
Clean dirty tracks.
Worn or damaged tracks must be repaired immediately.
Failure to do so will lead to reduced service life which could result in property damage and/or
personal injury.
5. Latch Inspection and Adjustment
Check locking latches for proper operation. Inspect for worn or missing parts. Replace worn or
damaged parts and adjust as required.
1. Latches
Check latch operation on all four corners.
2. Latch and Latch Bar Line-Up
Observe locking latches during lift operation to ensure that all latches line up with slots in latch
bar located in all four columns. If not, relocate and/or re-shim columns.
1. Check slack cable devices for proper operation. Inspect for worn or missing parts. Replace
worn or damaged parts as required.
2. Observe both locking latches and slack cable devices during lift operation to ensure that all
latches line up with slots in latch bar located in all four columns.
Cable Adjustment
1. Initial Adjustment
Adjust cable with lift fully lowered. Loosen jam nut and tighten nut on cable stud on top of
column until yoke end is raised 1/4” (6.4 mm) and back off nut one turn. Retighten jam nut.
Repeat for all four cables.
2. Final Adjustment
a. Load a typical vehicle on lift.
b. Raise lift as high as it will travel (full height). You should hear the locking latches click
through all latch slots simultaneously.
c. Lower lift onto top latch position.
d. Check clearance:
e. Starting with the right front column, use a straight edge to mark the position of the yoke
bottom on the column.
f. Raise lift to full height again. Mark second position. If gap between two marks is less
than 2”, adjust locking latch bar to reach clearance of 2”. Repeat for the other three