Product Manual

CO7338.1 2 IN20525 Rev D 3/30/2009
TABLE OF CONTENTS
• IMPORTANT INFORMATION pg 2
• OWNER / EMPLOYER RESPONSIBILITY pg 3
• LOCKOUT / TAGOUT pg 3
• SAFETY PROCEDURES pg 4
• LIFT SPECIFICATIONS & FLOOR PLAN pg 6
• TOOLS REQUIRED pg 7
• INSTALLATION INSTRUCTIONS pg 7
• CASTER KIT ASSEMBLY / INSTALLATION pg 10
• FOUNDATION & ANCHORING REQUIREMENTS pg 11
• OPERATION INSTRUCTIONS pg 13
• PREVENTIVE MAINTENANCE SCHEDULE pg 15
• TROUBLESHOOTING pg 17
• CABLE INSPECTION GUIDE pg 19
• ILLUSTRATED PARTS LIST pg 26
IMPORTANT INFORMATION
Four Post Lifts
1. Always inspect the lift for damage and make note of any damage on the bill of lading.
2. In case of freight damage, call the truck line immediately and report the damage as a
freight claim.
3. Make sure you have extra help or heavy duty lifting equipment when unloading and
assembling the lift.
4. Please read the safety procedures and operating instructions in this manual before
operating lift. Keep this manual near lift at all times. Make sure all operators read this
manual.
5. NOTE: Are you installing in a level location? (Lift must be anchored in place if
slope is greater than 1/8" per foot.)
6. Make sure you have enough room to install the lock rods. You will need at least 9’
of clearance from the opposite end of the power unit end of the lift and 6’ at
the power unit end. (See floor plan on page 6). The power unit may be installed
on the driver’s front or the passenger rear corner.
7. Never raise a car until you have double checked all bolts, nuts and hose fittings.
8. Always lock the lift before going under the vehicle or storing another vehicle
underneath lift. Never allow anyone to go under the lift when raising or lowering.
This is a vehicle lift installation/operation manual and no attempt is made or implied herein to instruct
the user in lifting methods particular to an individual application. Rather, the contents of this manual
are intended as a basis for operation and maintenance of the unit as it stands alone or as it is
intended and anticipated to be used in conjunction with other equipment.
Proper application of the equipment described herein is limited to the parameters detailed in the
specifications and the uses set forth in the descriptive passages. Any other proposed application of
this equipment should be documented and submitted in writing to the factory for examination. The
user assumes full responsibility for any equipment damage, personal injury, or alteration of the
equipment described in this manual or any subsequent damages.