Product Manual

CO7338.1 11 IN20525 Rev D 3/30/2009
ANCHORING TIP INSTRUCTIONS
CAUTION!!
Anchors must be at least 6” from the edge of the slab or any seam.
1. Use a concrete hammer drill with a carbide tip, solid drill bit the same diameter as
the anchor, ¾”. (.775 to .787 inches diameter). Do not use excessively worn bits or
bits which have been incorrectly sharpened.
2. Keep the drill in a perpendicular line while drilling.
3. Let the drill do the work. Do not apply excessive pressure. Lift the drill up and
down occasionally to remove residue to reduce binding.
4. Drill the hole to depth equal to the length of anchor. Note: Drilling thru concrete
(recommended) will allow the anchor to be driven thru the bottom of foundation if
the threads are damaged or if the lift will need to be relocated.
5. For better holding power blow dust from the hole.
6. Place a flat washer and hex nut over threaded end of anchor, leaving
approximately ½ inch of thread exposed carefully tap anchor. Do not damage
threads. Tap anchor into the concrete until nut and flat washer are against base
plate. Do not use an impact wrench to tighten! Tighten the nut, two or three turns
on average concrete (28-day cure). If the concrete is very hard only one or two
turns may be required. Check each anchor bolt with torque wrench set to 85 foot
pounds.