Product Manual
9000 lbs. Floor Plate Lift IN60001 Rev. C 11/6/2008
21
Safety and Operating Instructions
Only authorized personnel are to operate lift
Read operating and safety procedures manual completely before operating lift.
•
Properly maintain and inspect lift in accordance to owner’s manual.
•
Do not operate a lift that is damaged or in need of repair.
•
Allow only authorized personnel in the lift bay.
•
Stay clear of Lift when raising or lowering (NO RIDERS)
•
Keep hands and feet away from pinch points at all times.
•
Never override the Lift's operating and safety controls.
•
If a vehicle is suspected of falling, clear area immediately.
•
Do not rock vehicle while positioned on lift (except first 3" of rise when checking for stability).
•
Always use safety jack stands when removing or installing heavy components.
Vehicle Loading
•
Position vehicle for proper weight distribution (center of gravity should be midway between
adapters).
•
Swing arms under vehicle to allow adapters to contact the manufacturer’s recommended pick up
points.
•
Use caution before lifting pickup trucks, suv’s and other framed vehicles. The individual axle
weight capacity should not exceed 1/2 of lift capacity.
•
Make sure vehicle is neither front nor rear heavy.
•
Make sure the lifting pads are in a proper and safe position to support the vehicle. (Ref: Lifting
Points Guide and decal on Main side column for typical arm positioning)
Raising Lift
•
Push Up switch to raise lift (make sure arm restraints engage or stop and slightly move arm to
allow gear to mesh) until tires clear floor.
•
Stop and check for secure contact on adapters and vehicle weight distribution. If secure raise to
desired height.
•
ALWAYS lower the lift into the nearest lock position by pressing the lower lever to relieve the
hydraulic pressure and let the latch set right in a lock position.
•
Never work under a lift that is not in the locked position.
Lowering Lift
•
Clear all obstacles from under lift and vehicle and ensure only the lift operator is in the lift area.
•
Stay clear of lift and raise the lift off the safety locks.
•
Pull safety latch releases and press the lower lever to begin descent.
•
Unload lift by first completely lowering lift, then swinging arms to drive-thru position before moving
vehicle.
Lift Points Note: