Product Manual

9000 lbs. Floor Plate Lift IN60001 Rev. C 11/6/2008

STEP 10

: Installing the equalizing cables: (see diagram below) Loosen the two Cable Retaining

Bolts as shown. Route the first cable as shown. Tighten nut on one cable stud so that the end

of stud passes the nylon on the nut. Pull the other end of cable and run nut on it. Repeat above

for second cable. Once installed tighten the Cable Retaining Bolts.

NOTE: DO NOT tighten cables at this time. Just start them on the threads.

Cable

3/4” Nylon Insert Locknut

(Columns Not Shown For Clarity)

Pulley

Cable Retaining Bolt

Pulleys

Ø20 Washer

3/4” Nylon Insert Locknut

Cable

Carriage