User's Manual

6
(一) How to link with the host computer?
Turn on computer
1. Insert the receiver into USB jack of the host computer. User also can insert the
receiver into the jack of charging cradle. If user inserts receiver into charging
cradle, please connect the USB of charging cradle with the USB jack on host
computer.
2. Open the cover for battery cell on the mouse, and install two charged batteries
into the cell, then close the cover of battery cell. Please install the batteries by
following the instruction of negative and positive poles.
3. Turn the mouse down side up, and switch the button for power to “ON”.
4. Start operating dual mouse.
(1) Desk-top mode: The operating method is the same as normal 3D optical
mouse. Under desk-top mode, the orbit ball has no function. Please read
enclosed figures in detailed function.
(2) Palm mold (orbit ball mode): Hold dual mouse in the palm, and use thumb
to slide the orbit ball and control cursor. Under palm mode, the function of
optics inductor is without function. Please read enclosed figures in
detailed function.
5. unable to operate dual mouse, please follow below steps.
(1) Operate above 1 to 4 steps again.
(2) Press the ID button on the receiver for 1 or 2 seconds. At this moment,
the LED on the receiver will flash slowly for one minute.
(3) Please immediately press the linking button (during 1 minute) on the
bottom of dual mouse for 1 or 2 seconds. If the LED on receiver side
flashes quickly for 2 seconds, it shows that the link is successful. If the
7
LED on receiver side doesn’t flash for 2 seconds, please repeat step (2) and (3).
How to charge
1. ease plug the USB male head for charging cradle into USB jack on the host
computer.
2. Open the cover for battery cell on the charging cradle, and install the batteries
waiting for charging into the cell by following the instruction of positive and
negative poles.
3. Close the cover for battery cell. Charging cradle starts charging the batteries.
There are two indicator lamps on charging cradle. Red light shows that the
cradle is charging batteries, and green light represents that the battery is full.
Troubleshooting
1. After dual mouse is installed, wireless mouse cannot operate normally or is
without signals.
a. Make sure you have connected the receiver into the computer’s USB port.
b. Make sure you have installed the batteries correctly, and power has been
switched on.
c. Establish link between the receiver and the RF Dual function mouse. Press the
connect ID button on the receiver first, then press the connect ID button on the
RF Dual function mouse.
2. If the cradle can’t recharge, make sure that your batteries are NiMH batteries,
and they are installed correctly.
Notice!! Recharging function only works for NiMH rechargeable batteries. Other
batteries may be damaged under recharging function.