Installation Guide

8
INSPIRE RAILING INSTALLATION
Shim post as needed to
ensure post is level
Deck Board
Rim Joist
Joist / Blocking
Wood Block
1/2”
[13
mm]
Fig. 1
Fig. 2
CUTTING DOWN BOTTOM AND TOP RAILS
Step 1: Measure The Panel Opening Length
 1. Measurepanelopeningdistance.AsshowninFig.1.
 2. Conrmthatthemeasurementsforthetopbracketsare 
 thesameastheboombrackets.
Tip:
• Measure from the back wall of the bracket to the back wall
 ofthebracketonotherpost.AsshowninFig.2.
Fig.1
Fig.2
Measure the panel opening
Check measurement with top
DO NOT
measure from
post
Measure
from back
of bracket
Step 2: Mark Rails Where Cuts Will Be Made
 1. Takethemeasurementfoundinstep1aboveanddivideit
 inhalf.
 2. Findthecenteroftherailsandmeasureouthalfofthe
 lengtheachdirecon.AsshowninFig.1.
 3. Markthelocaonswithapencilonthetop&boomrail.
Tip:
• Beforecungrails,conrmspacingbetweencutmarkand
  outsidefaceofendpicketwillbelessthan4”[102mm].
 AsshowninFig.2.Adjustcutmarksasneeded.