Installation Guide

7
INSPIRE RAILING INSTALLATION
Fig. 1
6’panelmaximumpostspacingis69-1/4”
[1759mm]
8’panelmaximumpostspacingis93-1/4”
[2369mm]
Step 4: Mount Posts
 1. Markmounngholelocaonsandpre-drilla3/8”  
 [10mm]hole.
 2. Insert3/8”[10mm]x3-1/2”[89mm]HexHeadgalvanized
  boltsthrough3/8”[10mm]galvanized washer and post
 baseplate.
Note:
• Post Base Plate holes MUSTbeposionedaminimum
  1/2”[13mm]fromedgeofdeckboard.
 • Useonly3/8”[10mm]HexHeadGalvanizedBolts.Lag
Screws should NOTbeused.Secureeachpost
  withfourbolts.
Fig. 1 Fig. 2
OTP and Proud Post: Max Post Spacing
• 8’ panel maximum post spacing is 93-7/8”. • 6’ panel maximum post spacing is 69-7/8”. Note: Do not exceed the maximum post spacing.
8’ Panel max post spacing 93-7/8” 6’ Panel max post spacing 69-7/8”
OTP and Proud Post: Measuring The Panel Opening Length
• Measure the distance of the panel opening. • Measure from the back wall of the bracket to the back wall of the bracket on other post. • Confirm that the measurements for the top brackets are the same as the bottom brackets.
Measure the panel opening
Not here
Measure from
back of bracket
Check measurement with top
3/12
OTP and Proud Post: Max Post Spacing
• 8’ panel maximum post spacing is 93-7/8”. • 6’ panel maximum post spacing is 69-7/8”. Note: Do not exceed the maximum post spacing.
8’ Panel max post spacing 93-7/8” 6’ Panel max post spacing 69-7/8”
OTP and Proud Post: Measuring The Panel Opening Length
• Measure the distance of the panel opening. • Measure from the back wall of the bracket to the back wall of the bracket on other post. • Confirm that the measurements for the top brackets are the same as the bottom brackets.
Measure the panel opening
Not here
Measure from
back of bracket
Check measurement with top
3/12
Step 5: Check Mounted Posts
 1. Shimpostasneededtoensurepostislevel.
Note:
• DO NOTexceedthemaximumpostspacing.