Installation Guide

30
INSPIRE RAILING INSTALLATION
Fig.1
Step 3: Aach Panel To Brackets
 1. Pre-drillholesforscrewsusinga3/16”[5mm]drillbit.
 2. Pushthebracketupsothattheboomfaceisparallelwith
 theboomfaceofrail.AsshowninFig.1.
 3. AachthepaneltobracketsusingtheT-25thread-cung
screwsthatcamewiththebrackets.Twoscrewsare
  requiredineachbracket.AsshowninFig.2.
 4. Removeanymetalshavingsaeraachingthepanel.
Fig.1
Fig.2
Step 4: Mount I-Support To Deck Surface
 1. Unscrewthebaseunlitreachesthestairsurface.As 
 showninFig.1.
 2. InstalltheI-Supportusingtheprovidedwoodscrew.As
  showninFig.2.Pre-drillscrewholewitha1/16”[2mm] 
 drillbit.
Note:
 • TheI-Supportcanrotatetoanyangle0°to38°.The 
 heightoftheI-Supportcanchangefrom3.3”[84mm]upto
 5.7”[145mm].