Installation Guide

29
INSPIRE RAILING INSTALLATION
PANEL INSTALLATION
Step 1: Mount I-Support To Boom Rail
 1. Locatethecenteroftheboomrail. The I-support should
  becenteredandposionedbetweentwopickets. As
 showninFig.1.
 2. UsingtheI-Supportasaguide,markthecenterofthe2 
 screwholes.AsshowninFig.2.
 3. Usinga3/16”[5mm]drillbit,drillthoughtheoutsidewall.
 4. InstalltheI-SupportwiththeprovidedPhillipsHeadThread
 CungScrews.AsshowninFig.3.
Fig.1
Fig.2
Fig.3
Step 2: Install Panel
 1. Rakethepanelneartotheangleneededtoinstall.
 2. Dropthepaneldownintothebrackets.Conrmthatthe
 panelislevel.
 3. Removeanymetalshavingsaeraachingthepanel.