Installation Guide

28
INSPIRE RAILING INSTALLATION
 3. Checkendpicketposioningonallbrackets,pickets 
SHOULD NOTbeposionedinsidethebracketcup  
 spacing.AsshowninFig.1&2.
 4. Measurespacingfrominsideedgeofposttothepicket.
Spacing CANNOTexceed4”[102mm]oneachend.As 
 showninFig.3.
 5. Usealeveltoensurepicketsandpostsarebothstraight.
 6. Ifneeded,useshimstoleveltheposts.
 7. Clamppaneltopostin4places.
 8. Markcutpointsonpanelsinlinewiththebackofbracket
  opening.Besureboomofbracketisushwiththe
  boomoftherail.AsshowninFig.4.
 9. Usespeedsquaretoensuremarkingsareperpendicularto
 panel.
Fig.3
Post To
Baluster
Space
Must
Be Less
Than4”
[102mm]
Fig.4
Fig.1 Fig.2
Step 2: Cut & Clean Panel
 • Referencepanelcut&cleaninstruconsonpages9&10.
Step 3: Apply Spray Paint To Cut Areas
 • Referencespraypainnginstruconsonpage10.