Installation Guide

17
INSPIRE RAILING INSTALLATION
 5. Removeallmetalshavingsfromdeck,postbasecover, 
 post,andpanelbeforebracketisscrewedtopost.
Tip:
 • UseaBitExtender.
Fig.1
ANGLE BRACKET: POST MOUNTING
 • ReferencePostMounnginstruconsonpage6.
Fig.2
Assembled Angle Bracket
Without Cap
Angle Bracket Cap
(Tobeinstalledinalaterstep)
ANGLE BRACKET: CUTTING DOWN PANELS
Step 1: Determine Panel Length
 1. Use3/32”[2mm]HexWrenchtoghtenSetScrew&lock
  Bracketatrequiredangleposion.AsshowninFig.1.
 2. Checktoensurethatallpostsaresquareandstraight.Shim
  postsasrequired.
 3. EnsurethattheAngleBracketCupsareapproximately 
 aligned.