Installation Guide

16
INSPIRE RAILING INSTALLATION
ANGLE BRACKET
Inspire Railing: Angle Bracket Installaon opon
*Installed heights include a 3-1/2”[89mm] space between deck surface
andboomedgeofboomrail.
Inspire RailingPostConguraon
32-1/2”[826mm]
36”[914mm]
39-1/2”[1003mm]
Inspire Railing
Panel Height
Inspire Railing Panel
Installed Panel Height* Required Post
Post Cap
2-1/2”[64mm]
Post
Post Base Cover
I-Support
Inspire Railing Panels
69”[1753mm]or93”[2362mm]
Inspire Angle Bracket
ANGLE BRACKET: BRACKET INSTALLATION
Step 1: Install Angle Brackets
 1. AachAngleBracketBasepiecetothepostswithsupplied
 T-25thread-cungscrews.Usetwoscrewsperbracket.
  Uselowspeedsengondrill.Thesideofthebasewith 
 twoholesshouldbefacingdownwards. AsshowninFig.1.
 3. ReassembletheAngleBrackets,butDO NOT install the
 AngleBracketCapatthisme.AsshowninFig.2.