Installation Guide

14
INSPIRE RAILING INSTALLATION
Fig. 1
Step 1: Install Post Base Cover
 1. Separatethetwo-piecebaseplatecover.Holdoneside 
 paralleltothepostbaseplate.AsshowninFig.1.
 2. Place2ndhalfofthepostbasecoverontheoppositeside 
 ofthepost.Hold2ndpieceslightlyunderthe1stpiece.As
 showninFig.2.
 3. Twistthe2ndcover¼turnandmovepieceunlboth 
 halvestouch.AsshowninFig.3.
 4. Makesureoneofthelockingpinsonthe2ndcoverengage
 withtheproperslotonthe1stcoverpiece.As shown in
 Fig.4.
 5. Oncetherstlockingpinisstarted,turnthe2ndcover 
 piecebackparalleltothepostbaseplate.Oneyouhave
  conrmedbothlockingpinshaveengagedwiththe
  opposingslotslowerbothhalf’soverthepostbaseplate. 
AsshowninFig.5.
POST BASE COVER & BRACKET CAP INSTALLATION
Step 6: Aach I-Support To Deck
 1. Pre-drill I-support screw hole with a 1/16”[2mm]drillbit.
 2. FastenI-SupporttodecksurfacewiththesuppliedPhillips
 HeadWoodScrew.AsshowninFig.1.