Installation Guide

INSPIRE RAILING INSTALLATION

Step 4: Install I-support onto Boom Rail

 1. PosiontheI-supportasclosetothecenteroftheboom

 railaspossible.TheI-supportshouldbeinsertedbetween

 twopickets.AsshowninFig.1.UseaCrescentWrench 

 totwisttheI-SupportintoplaceAsshowninFig.2.

Step 5: Install Panel Into Brackets

 1. Installpanelintobracketstoconrmpropert.Conrm 

 thatpicketsareparalleltoposts.AsshowninFig.1.

 2. Pre-drilltopandboombracketholesforscrewsusinga 

 3/16”[5mm]drillbit.

 3. InstallT-25ThreadCungscrewsintobrackets.Asshown 

 inFig.2.

Note:

• Only one screw per bracket is needed to secure the

  paneltothebracket.

• Screws should be installed on the same side of all

  brackets.

Fig.2Fig.1

Fig.2

Fig.1