Instructions / Assembly

FENCING INSTALLATION: EVOLVER
9
When slotting the post over the post mount. Make certain that your rail slots are facing in the
correct direction for your fence boards.
Installation Guide - 2017 5
When slotting the post over the post mount. Make certain that your rail slots are facing in the
correct direction for your fence boards.
Installation Guide - 2017 5
Fig.1
Fig.2
Fig.3
Opposite
Fence
Board Slots
Opposite Fence
Board Slots
TOP VIEW
Step 1: Mount Post Base (Embedded/NoFoundaon)
 1. Create a perimeter for the fence using Ground Stakes &
  GuideString.Iflayouthas90°corners,conrmthatcorners
  form90°angles.Asshownonpage7,Fig.1.
 2. PosionPostBasesincornersalongstring.
 3. Determine spacing required between Corner & Line Post
 Bases.Spacing between each Post Base CANNOT exceed
73”[1860mm](FenceBoardwidthis70-1/2”[1791mm]).
Layout post spacing so that minimal panel cuts are
  required. AsshowninFig.1.
 4. Oncespacingisconrmed,Usespraypainttomark
  postholelocaons.
 5. Holesshouldbe10”[250mm]indiameter.Checklocal 
 buildingcodesforpostholedepth.
 6. PlaceEmbeddedPostBaseintoholesalongGuideStrings. 
 Postsshouldhaveatleast12”[300mm]exposed
POST INSTALLATION: EMBEDDED (NO FOUNDATION)
SECTION
VIEW