Instructions / Assembly

FENCING INSTALLATION: EVOLVER
7
POST INSTALLATION: NOT EMBEDDED (EXISTING FOUNDATION)
Required Components:
• Post Base (Not Embedded)
• Post
• Fastener
Note:
• Components can ONLY be purchased separately, not as
 partofafullkit.
Step 1: MountPostBase(NotEmbedded/ExisngFoundaon)
 1. Ifinstallingonaconcretepao,conrmthatthe
  paoislevel.
 2. CreateaperimeterforthefenceusingGroundStakes&
  GuideString.Iflayouthas90°corners,conrmthatcorners
  form90°angles.AsshowninFig.1.
 3. PosionPostBasesincornersalongGuide String.
 4. DeterminespacingrequiredbetweenCorner&LinePost 
 Bases.Spacing between each Post Base CANNOT exceed
73”[1860mm](FenceBoardwidthis70-1/2”[1791mm]).
Layout post spacing so that minimal panel cuts are
  required.AsshowninFig.2.
 5. Oncespacingisconrmed,Usepenciltomarkposionof 
 eachpostbase.
 6. Use3/8”[9mm]ConcreteAnchorstoanchorPostBasesto
 foundaon.AsshowninFig.3.
 7. UsealeveltoconrmthateachPostBaseismounted 
 straightata90
o
degreeangle.
Fig.1
90
o
90
o
90
o
90
o
HOUSE
Ground Stake
Foundaon
Guide String
TOP VIEW