User's Manual

ES520 Hardware Guide: Installation
18
2 Fix each bolt to the Mesh Point chassis with a wing nut,
tightened securely to the underside of the Mesh Point.
Figure 2.5. Attaching the Mast-Mounting Bracket and Grounding Stud
3 Position the Mesh Point at the desired position on the mast,
with the Mesh Point’s underside facing toward the mast and
the front panel facing down, as shown in Figure 2.5.
4 Sandwiching the mast between the underside of the Mesh
Point and the mounting bracket, fit the mast into the
toothed cut-outs in the mounting bracket and the bolt shafts
extending from the Mesh Point through the holes in the
bracket.
5 Place a split lock washer and then a wing nut on each of
the bolts ends, and tighten the nuts until the washers are
flattened against the mounting bracket.