User's Manual

ES440 Hardware Guide: Installation
5
Figure 2.1. ES440 Front-Panel Port and LED Locations
2.2 Port Locations
The ES440 Mesh Point’s power inlet, serial connector, Ethernet
connectors and USB port are located on the front panel (see
Figure 2.1).
All ES440 front-panel ports are protected by captive covers,
shown in Figure 2.2. Unused ports should remain covered to
protect against dust and other debris. Covered or uncovered,
all ES440 ports are waterproof.
Figure 2.2. ES440 Front Panel with Port Covers
CAUTION: The
back-panel screw
cap must be installed in
order for the ES440 to be
watertight.
Four antenna connectors are situated on the ES440 back
panel, corresponding to the ES440’s internal radios, as shown
below.
Figure 2.3. ES440 Back-Panel Antenna Connectors and Recessed Button
LEDs
USB port
Ethernet 2,
default clear
Ethernet 1
serial port
power inlet
ports
Radio 4
Radio 3
Radio 2
Radio 1
Ethernet 1
PoE input,
default
encrypted
Ethernet 2Status
Power
antenna port Radio 2
recessed button screw cap
(restore defaults)
antenna port Radio 3
antenna port Radio 4
antenna port Radio 1