User's Manual

ES2440 Hardware Guide: LEDs and Button Operation
13
3.2 Recessed Button Operation
The single recessed button on the ES2440 front panel (shown
in Figure 2.1) returns the ES2440 Mesh Point to the factory
default configuration.
The button is covered by a screw cap that you must remove, in
order to access the button. You must replace the screw cap,
in order to maintain the watertight integrity of the ES2440
chassis.
To restore default settings, depress and hold the button for 10
seconds. All current configuration information on the running
boot partition will be lost.
Table 3.1. LED Indicators in the ES2440
color behavior
Power Status
Ethernet1,
Ethernet2,
Ethernet3
Link/Act
Radio1, Radio2,
Radio3, Radio4
a
green
solid normal operation - link established radio ON
slow flash booting
Auto-Config
distribution
--
intermittent - - passing traffic passing traffic
off powered OFF - -
radio OFF
or
RF Kill enabled
a. Present only on radio-equipped ES2440s, according to the number of radios installed. Corresponding LEDs S1,
S2, S3, and S4 on ES2440s equipped with fewer or no radios are reserved for future functionality.