User's Manual

ES2440 Hardware Guide: Installation
10
NOTE: LED indica-
tors are covered in
Section 3.1
7 Verify that the Power LED illuminates, as well as the
corresponding LEDs for all connected ports and enabled
radio(s).
2.2.2.2 Connecting the ES2440-3444 or
ES2440-34 for Deployment
Connection procedures for the ES2440-3444/34 are identical
to those provided for the ES2440-3555 above, except that
MIMO is not an option for its 4.4 GHz radios (
Radio 2, and
Radio 3 and Radio 4, if present). Only a single antenna port is
therefore present for each of these radios, and the second part
of Step 3 in Section 2.2.2.1 does not apply.
2.2.2.3 Connecting the ES2440-0 for Deployment
1 Ground the ES2440-0 by connecting a ground wire to the
ES2440’s grounding stud located on the left rear corner of
the chassis (refer to Figure 2.1).
CAUTION: Out-
door antennas,
connectors, and cables
must be waterproof.
2 If the Mesh Point’s GPS function will be used, connect an
SMA GPS antenna to the
GPS antenna port.
3 Connect the front-panel Ethernet port(s), according to the
requirements of your deployment, using standard Cat5e
cable(s) to
Ethernet1/WAN/POE (default encrypted), and/or
to
Ethernet2 and/or Ethernet3 (both default clear).
NOTE: If you have
obtained an alter-
native powering device
from Fortress, refer to
Section 2.1.2,
Powering
Options
, for detailed in-
structions.
4 Connect the DC power connector/cable assembly included
with the ES2440-0 to a 11–32 VDC power source, and
apply power to the ES2440-0 through the
DC Power inlet.
5 Verify that the Power LED illuminates, as well as the
corresponding LEDs for all connected Ethernet ports.
2.2.3 Disconnection
To disconnect and power down the ES2440, depending on the
power source in use by the ES2440:
 Remove AC power from the PoE+ adapter/injector to which
the ES2440 is connected by unplugging the adapter/
injector’s power cord from the wall.
or
 Remove DC power from the ES2440 by unplugging the DC
power cable connector from the ES2440’s
DC Power inlet.