- Fortress Wireless Access Bridge User Guide

Fortress Bridge: Configuration
48
To enable/disable blackout mode:
1 Log on to the Bridge GUI admin account and select SYSTEM
OPTIONS from the menu on the left.
2 Under BLACKOUT MODE, in the Status field choose to Enable
BLACKOUT MODE (turn the LEDs off) or Disable BLACKOUT
MODE (turn the LEDs on).
3 Click OK in the BLACKOUT MODE frame.
You can also enable/disable blackout mode through the
Bridge’s front-panel switches (refer to Section 3.10.1.2)
3.8 System Date and Time
NOTE: The SYSTEM
DATE AND TIME
screen f eatures an infor-
mational timestamp.
The refresh function of
your browser updates
this timestam p.
To change the date and time on the Bridge:
1 Log on to the Bridge GUI admin account and select SYSTEM
OPTIONS from the menu on the left.
2 At the top of the SYSTEM OPTIONS screen, under SET SYSTEM
TIME, enter the time and date, using two-digit values,
according to the format:
hh:mm MM:DD:YY.
3 Click Apply at the bottom of the SET SYSTEM TIME frame.
3.9 Restoring Default Settings
The Fortress Bridge’s factory default configuration settings can
be restored in their entirety through the Bridge CLI (refer to
Section 6.4.7) or via the front-panel switches (refer to Section
3.10.3).
After default settings are restored, the Bridge will have to be
reconfigured for use, just as though it were newly installed, out
of the box.
Because the Bridge’s configuration settings could themselves
be sensitive, Fortress Technologies recommends restoring
them to their default values whenever the Bridge is to be
shipped (or otherwise transported) out of a secured location.
detail:
detail: