Installation Guide

Install Brackets to Posts
• Using pre-drill dimensions previously given, pre-drill holes on installed posts with a 3/16” drill bit.
13 13
• If using Al Post Base Covers, install at this time by sliding over the top of the Al Posts.
• Secure Evolve External Bracket Cups to posts with provided T-25 Drive Thread-Cutting Screws.
Use low speed setting on drill.
Evolve
External
Cup
Evolve
External
Cup
Evolve
External
Cup
Evolve
External
Cup
Install Bottom Rail of Pure View Full Glass Panel
• If rails were cut to length, file cut edges and coat with 2 coats of Fortress zinc based touch-up paint.
• Install PureView Full Glass Panel I-support, center support on bottom surface of bottom rail. Pre-drill holes with a
3/16” drill bit, and secure with provided Phillips Drive Thread-Cutting Screws. Use low speed setting on drill. Check
fit of rail between posts before installing I-Support.
• Drop bottom rail of Pure View Full Glass Assembly into the lower installed brackets.
• Secure rail to Evolve External Bracket Cups with provided T-25 Drive Thread-Cutting Screws. Use low speed setting
on drill.
Evolve
External
Cup
Evolve
External
Cup
Evolve
External
Cup
Evolve
External
Cup
Set Screw
PV FGP I-Support
3/4