Sol-Ark Integration Guide

4. CAN should now be set to 6
Step 1 - Adjust the SolArk Settings
1. Change the SolArk Batt Settings to
match the following
2. Use Batt % Charged
3. BMS Lithium Batt should be set to: 00
4. Activate Battery Checked
Step 1 - Checking SolArk Data Display
1. If everything is configured correctly
you should now see a button labeled
Lithium Batt Info
2. After opening this window on the
SolArk you should see the following
screen with real time data.
3. Note: While this screen is very different
from the MODBUS preview, but still
only shows aggregate reported
data
from the entire battery bank
Appendix 1 - eFlex Comm Port Pinout
eFlex Comm Port
Pin Assignment
1 CAN1_H
2 CAN1_L
3 RS485A2 (not used)