Manualshelf

Sol-Ark Integration Guide

ManualsBrandsFortress Power ManualsSolar & Wind PowerEVault Max 18.5 kWh Lithium Ferro Phosphate Battery
11121314151617181920
EVMX - Setting Up CAN communication
NOTICE
The following instructions are not usable on the general release firmware of the eVault Max firmware, they are considered
pre-release and should not be used outside of engineering supervision.
Step 1 - Fabricate the Communication Cable
SolArk 8k
SolArk 12k
SolArk Side
1. Pins 4/5 (CAN_H/CAN_L) are used by
the SolArk for battery CAN
communication
2. Pin 6 (logic ground) should also be
connected
3. This bus runs at 500kbps internally.