Eflex Install Manual

Rev. 1.92
505 Keystone Rd, Southampton, PA 18966, USA . [phone]. [e-mail] .
www.fortresspower.com
16
3. Once all brackets are properly positioned, carefully lift the battery
with the help of someone and gently drop it into the female wall
mounted brackets
Note: the eFlex may be wall mounted in any orientation except for sideways
with the terminals near the ground (see section 4.4.2 floor mount installation
for picture)
4.4.2 Floor mount installation
The eFlex 5.4 can be floor-mounted in several orientations. The
orientation depicted to the right, with the terminals towards the
ground, is the only orientation NOT allowed. All other orientations are
allowed, but regardless of orientation, the included floor mounting bracket
must be used to prevent the battery from tipping over. Therefore, it is
common to put the back of the eFlex battery against the wall.
1. Place the eFlex in the preferred orientation
2. Attach the mounting bracket using the T-slot fastener and T-slot
groove on the back of the eFlex
3. Screw the mounting bracket into the wall
4. Connect the battery terminals to the corresponding bus bar and
inverter