Installation Manual

Water Line Connection

STEP 8 – CONNECT DRAIN LINE

FOLLOW ALL LOCAL CODES AND ORDINANCES.

The drain hose molded end will fit 5/8” 3/4” or 1” diameter

connectionson the air grap, waste tee or disposer. Cut on the

marked line as required for your installation.

Figure L

Cutting Lines

3/4"

5/8"

IMPORTANT: Do not cut corrugated portion of hose

If a longer drain hose is required, add up to 42” of length for a

total of 10 ft. to the factory installed hose. Use 5/8” or 7/8” inside

diameter hose and a coupler to connect the two hose ends.

Secure the connection with hose clamps.

Figure N

Hose Clamp with clamps.

Coupler

Hose Clamp

NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10

FEET FOR PROPER DRAIN OPERATION.

Connect drain line to air gap, waste tee or disposer using either

previously determined method.

Method 1 -Air gap with waste tee or disposer

Method 2 -High drain loop with waste tee or disposer

Figure M

Figure O

Waste Tee Installation Disposer Installation

Draining hose hanger

32"

Min.

Draining hose hanger

18"

Min.

32"

Min.

18"

Min.

Waste Tee Installation Disposer Installation

INSTALLATION