Installation Manual

BEFORE YOU BEGIN
STEP 1 – HANDLEBAR ASSEMBLY
STEP 2 – CHECK DOOR BALANCE
Use a hex wrench to install the outside door handle.
This step is only applicable to the F18DWS250SS model.
Figure G
Hexagon wrench-M6
Figure H
After placed the panel on the dishwasher, please try open and
close the door to test the balance to check out whether
the door can remain a same place. If not, please adjusting the
screw in the direction of clockwise or counterclockwise to
adjust the balance of the door.
This step is only applicable to the F18DWS250SS model.
+
-
Hexnut tools
CR-V
30°~90°balance
9
INSTALLATION
INSTALLATION
0.157inch
6.61~15.43lbs