Operation Manual

APPENDIX A
System Software and Utilities
The system software and utilities provided with your VFX1 Headgear system are
described below. During the software installation (see Chapter 4), these programs
are transferred to your hard disk and stored in the directory specified. Also, the
VFX1 directory name is added to the path statement in your computer's
autoexec.bat file so that the VFX1 programs can be accessed at any time without
having to manually select the directory.
To start a program, at the DOS prompt type:
program <enter>
where program is the name of the actual program you want to run. Some of these
programs take optional target values and command line switches which invoke
special functions. Command line options are listed with the program descriptions
below. The general syntax for specifying these functions is:
program xxxxxxxx -y <enter>
where program is the name of the actual program you want to run, xxxxxxxx is
the optional target value, and -y is the optional command line switch.
INSTALL DISK Contents
README ASCII file which contains the latest information and changes
made to the product after the documentation was printed.
INSTALL Installation program which creates a VFX1 directory on your
hard disk and transfers the VFX1 software to your system (see
Chapter 4).
SETVFX1 VFX1 setup program used to set VIP Card values, adjust the
optics, and test and calibrate the system (see Chapter 4).