Operation Manual

CHAPTER 4
Software Installation & Setup
With the hardware setup completed, we are now ready to install the system
software and complete the VFX1 installation by running the SETVFX1 setup
program.
Installing the System Software
A global software installation program is provided with the FORTE VFX1
HEADGEAR System. To perform the software installation:
• Insert the VFX1 HEADGEAR INSTALL DISK in your floppy drive.
• At the DOS prompt, type:
A: INSTALL <enter>
assuming "A" is your floppy drive (change "A" to the letter of the actual
drive used if different).
The INSTALL program will search for the hard disk drives on your computer that
have enough room to install the system programs and will prompt you to select
where you would like the software loaded (the default is C:\VFX1).
After the system software is transferred, the INSTALL program automatically
loads and runs SETVFX1, the VFX1 HEADGEAR setup program described below,
taking you directly to the SETUP VIPPORT menu option to confirm and test
the VIP card settings.
Running the SETVFX1 Setup Program
The SETVFX1 setup program is a menu-driven utility which provides options for:
· VIP Card Setup - SETUP VIPPORT
· VFX1 HEADGEAR Optics Setup - SETUP OPTICS
· VFX1 HEADGEAR Tests - TEST VFX1
· CyberPuck Tests - TEST CYBERPUCK
· Field Calibration - CALIBRATE