Operation Manual

Chapter 3 - Hardware Installation
□ Remove the expansion slot's cover by removing its retaining screw and lifting
the cover straight out. Put the screw in a safe place because you will need it
to secure the VIP Card after it has been installed.
STEP 3. Prepare the VIP Card
□ Making sure that you are first grounded, remove the VIP Card from its
antistatic bag.
□ Set/Confirm the VIP Card I/O Address Setting - The VIP Card has a jumper
at the bottom of the card for selecting the Input/Output (I/O) address that it
uses to communicate with your computer. The jumper is a block with 4 pins
and two removable plastic hoods. The plastic hoods each fit over a pair of
pins on the jumper. The VIP Card illustration on the following page shows the
location of the I/O Address jumper and hood locations for each of four (4)
possible addresses. Confirm that the removable hoods are set to the factory
preset positions. This configuration should be acceptable for most uses and
will require changing only if it conflicts with the I/O Address setting of
another card.
3-3