Operation Manual

STEP 5 Make Final Connections

(see page 3-7)

□ Attach supplied 8' interconnect cable between the VIP Card and

the VFX1 HEADGEAR. □ Plug the CyberPuck connector into

the ACCESS.bus port located

at the rear of the VFX1 HEADGEAR or the port located on the

VIP Card. □ Optional: Attach the supplied mini-phono cables

between the

VIP Card and your sound card.

STEP 6 Install VFX1 HEADGEAR Software

□ Insert the supplied INSTALL DISK in your floppy drive. □

At the dos prompt type:

A:INSTALL <enter>

assuming "A" is your floppy drive (change "A" to actual drive

letter as required). Follow the program instructions to complete

the installation.

NOTE: After the system software is transferred, the Install program

automatically loads and runs the VFX1 HEADGEAR setup program

SETVFX1 to perform STEPS 7-9 below.

STEP 7 Setup VFX1 HEADGEAR Interface Protocol (VIP) Card

□ If you changed the base I/O address, select the new value.

□ Select an IRQ that does not conflict with other adapters. □

Test selections and accept.

STEP 8 Adjust VFX1 HEADGEAR Optics

- Select SETUP OPTICS from the

SETVFX1 main menu. Refer to chapter 4 of the manual and proceed

as directed in the VFX1 HEADGEAR Optics Setup section. It is

imperative that the optical adjustments be completed before using the

VFX1 HEADGEARsystem (see Safety First!!! on page vi).

STEP 9 Test the VFX1 HEADGEAR System

- Select TEST VFX1 and TEST

CYBERPUCK from the SETVFX1 setup program main menu and

confirm that the system is working correctly.

STEP 10 Install applications from the BONUS CD-ROM

□

Insert supplied BONUS CD-ROM in drive. □ At

the DOS prompt type: D:INSTALL <enter>

assuming "D" is your CD-ROM drive (change "D" to actual drive

letter as required). Follow installation program instructions to

complete installation.