Installation Sheet

INSTALLATION INSTRUCTIONS

For Model 7117-06

READ AND SAVE THESE INSTRUCTIONS

These instructions are provided for your safety. It is essential to read them carefully and completely before installing the

light fixture. We strongly suggest that all direct-wired fixtures be installed by a qualified, licensed electrician.

ASSEMBLING THE FIXTURE

Rota Adjust three place arms (L) (M) (N) to a desired angle and

tighten the allen screws(D) using an allen wrench(H).

CONNECTING THE WIRES

Attach the fixture’s wire to the power supply wires at the junction

box. Connect the black wire to the black wire(or smooth), the

white wire to the white(or ribbed), the ground wire to the ground

wire(green or copper). Twist the end of the wire pairs together,

and twist on a wire connector. Make sure all twists are in the same

direction. If there is no ground wire(green or copper) from the

junction box, locate the ground screw(E) on the mounting plate(A)

and wrap the fixture’s ground wire around the green ground

screw(E). Use a screwdriver to secure the ground screw(E) onto

the mounting bracket. Tuck all wires neatly into the junction box.

PREPARING FOR INSTALLATIONS

Remove all contents from the carton. See the important notes

above. Shut off the power at the circuit breaker and completely

remove the old fixture from the ceiling, including the

old mounting strap.

Rotate both of the allen screws (D) clockwise into the binding

collar (C) using the allen wrench(H) until tight.

If needed, cut off any remaining excess steel cable (I)

using a wire cutter so the steel cable(I) and binding collar (C)

can properly fit the inside of the final assembled canopy (G). FINISHING THE INSTALLATIONS

Gently pull the existing wire down from the ceiling

junction box and allow wires to hang.

Attach the mounting plate (A) to the ceiling outlet box, and align Install light bulb(s) (not included) in accordance

the slots of the mounting plate (A) with two threaded holes with the fixture’s specifications.

located on the J-Box. Do not exceed the recommended maximum

Secure the mounting plate (A) by tightening 2 mounting screws (F) wattage.

with a screwdriver. Your installation is now complete. Turn on the power

Secure the mounting plate(A) to the junction box by securely and test the fixture.

tightening the mounting screws(F).

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER

BEFORE INSTALLATION

AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.

PAGE 1
INSTALLATION INSTRUCTIONS For Model 7117-06 READ AND SAVE THESE INSTRUCTIONS These instructions are provided for your safety. It is essential to read them carefully and completely before installing the light fixture. We strongly suggest that all direct-wired fixtures be installed by a qualified, licensed electrician. WAR NI NG ! S H UT PO W ER O F F AT F U S E O R CI RC UIT B R E AK E R BE FO R E I N STAL L AT I O N AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.