Installation Sheet

Page 1 of 2

INSTALLATION INSTRUCTIONS

Model# 2763-01

1 LIGHT PENDANT

! Warnings and Cautions

 Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if you are

in doubt.

 These instructions are provided for your safety. It is very important you read them completely before installing

fixture. We strongly recommend that a licensed, professional electrician perform the installation.

 Turn off fixture at the switch before replacing the bulbs.

- Make sure bulbs are given sufficient time to cool before removal.

- Do not subject glass parts to any shock while in operation or shattering may result.

Tools Required (Not Included): Flathead screwdriver, Phillips screwdriver, Wire cutters, Electrical tape, Safety

goggles, Ladder.

Helpful Tools (not included): Wire strippers.

ASSEMBLY INSTRUCTIONS

1. Carefully unpack and lay all parts on a clean, level

surface. Do not discard any contents until after

assembly is complete to avoid accidentally discarding

small parts or hardware.

2. Unscrew the pre-assembled locking ball nut (G) from

the mounting bracket (B). Attach the mounting

bracket (B) to the junction box (not included) with the

junction box screws (D).

3. Loosen the Allen Strain Relief Screw (H) from the

threaded collar using the Allen Wrench (I) by turning

the wrench counter-clockwise. Adjust the power cord

(J) upwards or downwards through the canopy (F)

until the desired suspension length is determined.

Secure the power cord (J) in place by tightening the

Allen Strain Relief Screw (H). Do not over tighten the

screw, making sure the power cord (J) will not slip

downwards with the pendant body.

PAGE 1
INSTALLATION INSTRUCTIONS Model# 2763-01 1 LIGHT PENDANT !  Warnings and Cautions Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if you are in doubt.  These instructions are provided for your safety. It is very important you read them completely before installing fixture. We strongly recommend that a licensed, professional electrician perform the installation.  Turn off fixture at the switch before replacing the bulbs.
PAGE 2
4. Use the wire connectors (supplied) to connect the wires (See diagram above). Connect the house ground wire to the fixture ground wire. Connect the house white wire to the fixture supply wire (ribbed sided). Connect the house black (or red) wire to the fixture supply wire (smooth side). Wrap each connection with approved electrical tape and carefully stuff all of the connected wires into the outlet box. 5.