Installation Sheet

Page 2 of 2
ASSEMBLY INSTRUCTION
1. Carefully unpack and lay all parts on a clean, level surface. Do not discard any contents until after assembly is
complete to avoid accidentally discarding small parts or hardware.
2. Attach the threaded end of the short stem (k) to the socket assembly (L), turning the stem in a clockwise
direction until snug. Unscrew the pre assembled locking cap (G) from the crossbar assembly (B). Attach the
mounting bracket (B) to the junction box (not included) with junction box screws (C).
3. Loosen the Allen remove Strain Relief Screw (H) remove using the Allen Wrench (I) by turning the wrench
counter-clockwise. Adjust the power cord (J) upwards or downwards through the canopy (E) until the desired
suspension length is determined. Secure the power cord (J) in place by tightening the Allen Strain Relief screws (H)
remove. Do not over tighten the screw, making sure the power cord (J) will not slip downwards with the pendant
body.
4. Use the wire connectors (supplied) to connect the wire.
(See diagram to the right). Connect the house ground
wire to the fixture ground wire. Connect the house
white wire to the fixture supply wire (ribbed sided).
Connect the house black (or red) wire to the fixture
supply wire (smooth side). Wrap each connection
with approved electrical tape and carefully stuff all
of the connected wires into the outlet box.
5. Place the canopy (E) Up to the ceiling junction box, Place the ceiling canopy over the nipple on the crossbar assembly
and secure with the locking cap (G).
6. Remove the Pre-assembled socket ring (O) and spacer (N) from the socket assembly (L).
Position the shade (M/P/Q) and spacer (N) over the socket, then secure with socket ring (O).
7. Install the bulb (not included).
Install correct bulbs referring to fixture markings and/or labels for maximum wattage.
8. Your installation is now completed. Restore electricity to test for connectivity. If there are any issues turn power
off at the circuit breaker and double check to make sure the wires are connected properly. Retain this sheet for
future reference.
CLEANING AND MAINTENANCE
1. Wipe clean using soft, dry cloth or static duster.
2. Always avoid using harsh chemicals and abrasives to clean fixture as they may damage the finish.