Installation Sheet

Page 1 of 2

INSTALLATION INSTRUCTIONS

Model# 2760-03

3 LIGHT PENDANT

! Warnings and Cautions

 Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if you are

in doubt.

 These instructions are provided for your safety. It is very important you read them completely before installing

fixture. We strongly recommend that a licensed, professional electrician perform the installation.

 Turn off the fixture at the switch before replacing bulbs.

- Make sure bulbs are given sufficient time to cool before removal.

- Do not subject glass parts to any shock while in operation or shattering may result.

Tools Required (Not Included): Flathead screwdriver, Phillips screwdriver, Wire cutters, Electrical tape, Safety

goggles, Ladder.

Helpful Tools (not included): Wire strippers.

Parts Included:

(B) Crossbar Assembly (1)

(E) Canopy (1)

(H) Collars (3)

(J) Power Cord (3)

(L) Sockets (3)

(N) Spacers (3)

(O) Socket Rings (3)

(M) 8” Dia. Glass Shade (1)

(P) 10” Dia. Glass Shade (1)

(Q) 12” Dia. Glass Shade (1)

Hardware Enclosed:

(A) Plastic Wire Nut Connectors (3)

(L) Allen Wrench (1)

PAGE 1
INSTALLATION INSTRUCTIONS Model# 2760-03 3 LIGHT PENDANT ! Warnings and Cautions  Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if you are in doubt.  These instructions are provided for your safety. It is very important you read them completely before installing fixture. We strongly recommend that a licensed, professional electrician perform the installation.  Turn off the fixture at the switch before replacing bulbs.
PAGE 2
ASSEMBLY INSTRUCTION 1. Carefully unpack and lay all parts on a clean, level surface. Do not discard any contents until after assembly is complete to avoid accidentally discarding small parts or hardware. 2. Attach the threaded end of the short stem (k) to the socket assembly (L), turning the stem in a clockwise direction until snug. Unscrew the pre assembled locking cap (G) from the crossbar assembly (B). Attach the mounting bracket (B) to the junction box (not included) with junction box screws (C). 3.