Installation Sheet

Page 2 of 2
4. Use the wire connectors (supplied) to connect the wires (see diagram above). Connect the house ground wire to
the fixture ground wire. Connect the house white wire to the fixture supply wire (ribbed sided). Connect the
house black (or red) wire to the fixture supply wire (smooth side) Wrap each connection with approved electrical
tape and carefully place all of the connected wires into the outlet box.
5. Place the canopy (F) up to the ceiling junction box, allowing the pre-assembled screws on mounting bracket (B)
to pass through the canopy (F) and secure with locking ball nuts (G).
6. Remove the pre-assembled socket ring (O) and the spacer (N) from the socket assembly (L).
Position the shade (M) and the spacer (N) over the socket, then secure with the socket ring (O).
7. Install the bulb (not included).
Install correct bulbs referring to fixture markings and/or labels for maximum wattage.
8. Your installation is now completed. Restore electricity to test for connectivity. If there are any issues turn power
off at the circuit breaker and double check to make sure the wires are connected properly. Retain this sheet for
future reference.
CLEANING AND MAINTENANCE
1. Wipe clean using soft, dry cloth or static duster.
2. Always avoid using harsh chemicals and abrasives to clean fixture as they may damage the finish.